How to use dry processing to solve the problem of water content in the dry kiln vertical roller mill?

The working mechanism of vertical roller mill is relatively simple, and the choice of materials is relatively loose. Under normal circumstances, most brittle materials can be processed by Vertical Roller Mill when the Mohs hardness requirements are met. However, there is a kind of vertical grinding because of the technology of dry processing, and the actual material processing process often contains more water. In this case, the use of vertical roller mill production will inevitably have a certain impact on the whole production process. The influence of material humidity on the operation of the vertical roller mill equipment, the analysis of the situation of the Henan vertical roller mill work site will be introduced to everyone. In fact, as far as vertical roller mill is concerned, the water content of the crushed material has a great influence on its overall performance. Due to the variety of mills, and the different types of kiln vertical roller mill requests for material moisture content are very different. However, with regard to ordinary milling equipment, the higher the water content, the more unfavorable the normal grinding of the equipment, and the coarser water content of the material below 6 percent is better. It can be seen that the water content of the material has a great influence on the normal operation of the STM vertical roller mill.
The water content of the material is relatively large, so when the dry kiln vertical roller mill is in operation, it is impossible to directly run the milling powder. This is because the water content of the two-denier material is large, and the water will be brought into the grinding chamber. Thus, when it is operated, the heat will be generated from time to time to change the air movement in the room, and the normal movement path of the gas will also change. At this time, the equipment will enter the outside air from time to time, which brings about a small amount of problems or a blast. There are many problems with the water content of the material. At present, the more common disposal method is the dry processing method. In this way, the water content of the material should be kept below 6 percent at the time of operation, and the material structure should be stable. First run the vertical roller mill to stop the crushing of large pieces of material and make it meet the qualified request for consumption. Then stop grinding, dusting, noise removal, etc., and compare the waste products that have been ground out of the kiln to the request specification. When the STM vertical roller mill was in operation, it was affected by the humidity of the material. After the careful introduction of the above, everyone had a better understanding. In this case, the user who prompts the two cuts should stop strictly according to the consumption request when stopping the consumption of the vertical kiln vertical roller mill, and reduce the humidity of the material as much as possible, so as to ensure the normal operation of Henan vertical roller mill and ensure its sufficient service life.

评论

此博客中的热门博文

Artificial aggregate production process and advantages and disadvantages

Raymond Mill grinding system new advantages

New sand maker consolidates infrastructure construction